close
close

How To Light Pilot Light On Ventless Gas Fireplace

th 2552

How To Light Pilot Light On Ventless Gas Fireplace. How to light pilot light on ventless gas fireplace. How to light the pilot on a monessen gas fireplace.

Gas Fireplace Pilot Light Goes Out When Turned To On
Gas Fireplace Pilot Light Goes Out When Turned To On from decorlighting.port-media.org

Remember to shut the gas supply valve off (picture #1). Gas fireplaces have the system of ignition based on the pilot light stand that provides flame and the thermocouple that sends an electric signal for the gas valve. This makes the fireplace easy to start when it's cold outside, but during the warm seasons when you aren't using the fireplace, it's a.

Reset The Knob To The Pilot Position:

Keep a close eye on your pilot light once you have restored the flame. Remember to do this when you are ready to ignite the pilot light of your gas fireplace. How to light pilot light on ventless gas fireplace.

You Can Also Check With Your Gas Provider To Find Out If You Have Had Your Supply Interrupted.

If the pilot light goes out, repeat steps 5 & 6. The pilot burner could also be behind a small panel. If your ignitor is broken, make sure to get your fireplace serviced prior to your next session.

How Much Does It Cost To Replace The Pilot Light On A Gas Fireplace?

Push in the pilot knob, which will then manually send gas into the system. After lighting gas logs pilot light, set the handle to the “on” position. Depending on how long it’s been since the gas fireplace was last used, ignition may take several attempts before igniting.

The Pilot Light On Your Gas Fireplace Is Powered By A Small Gas Flow.

Push the igniter button once every second until it lights. How to light pilot light on ventless gas fireplace. Often, this will involve manually depressing the pilot valve and using an electric ignitor or match to light the pilot.

If Gas Is Coming Out Of The Pilot, But It Still Won't Light, The Spark Igniter Could Be The Problem.

As you hold the control knob press the piezo ignitor button that will produce a “snapping” noise. If the pilot does not light, wait 5 minutes and try again. Push the igniter button once every second until it lights.

Leave a Reply

Your email address will not be published.